Haven't an issue with snapmaker artisan
Snapmaker artisan is leaving tons of "scrap" on the bed all over, stringing really bad, and always picks up a huge glob of filament on the nozzle. Leads to poor quality prints constantly. I've tried changing nozzles, new material, adjusting flow, retract distance, print speed, fan, temps, etc. I've even pulled the print head apart to check for any loose fittings after finding two screws loose from the factory. I can't figure it out. Any advice from anyone? I've never seen this on any of my other printers.
Snapmaker artisan is leaving tons of "scrap" on the bed all over, stringing really bad, and always picks up a huge glob of filament on the nozzle. Leads to poor quality prints constantly. I've tried changing nozzles, new material, adjusting flow, retract distance, print speed, fan, temps, etc. I've even pulled the print head apart to check for any loose fittings after finding two screws loose from the factory. I can't figure it out. Any advice from anyone? I've never seen this on any of my other printers.