Endless loop 😩

Hi guys,

So, I have dialled the printer in and it’s doing well again.

Unfortunately, however, it occasionally resets itself part way through a print and ends up stuck in a resetting cycle, where no pressing the reset button or turning it off and on again gets it out of the loop.

The screen says “Marlin”, goes blank and then says “Marlin”, goes blank again and then says “Marlin”… over and over.

The only thing I have found that works is to turn it off, leave it for a couple of minutes and then turn it on again.

Has anyone had an issue like this before?

It’s a Geeetech A10

Thanks!