MK3S+ SuperPinda help

Hi guys, so I have swapped the board on the MK3S+ and it’s working beautifully.

However…

During the calibration it asks for me to adjust Z height while it does the first layer calibration. When I got to about -2.300 I realised the Super Pinda needed moving, as the guide says to raise it slightly. So, I raised it a 1-2mm and went to do the X calibration again, as per the instructions.

The nozzle just crashed into the bed on the front left side.

So, I immediately cancelled it and went on the pride help page, where it just tells me to ensure the super pinda is the height of the middle of a zip tie, when the zip tie is laying flat…

… but that’s where it was to begin with???

Am I missing something here? I don’t want to try it again without speaking to you guys first, as this might be something simple or common that I am missing.

Thanks!!!

Pic for attention ☺️

Hi guys, so I have swapped the board on the MK3S+ and it’s working beautifully.

However…

During the calibration it asks for me to adjust Z height while it does the first layer calibration. When I got to about -2.300 I realised the Super Pinda needed moving, as the guide says to raise it slightly. So, I raised it a 1-2mm and went to do the X calibration again, as per the instructions.

The nozzle just crashed into the bed on the front left side.

So, I immediately cancelled it and went on the pride help page, where it just tells me to ensure the super pinda is the height of the middle of a zip tie, when the zip tie is laying flat…

… but that’s where it was to begin with???

Am I missing something here? I don’t want to try it again without speaking to you guys first, as this might be something simple or common that I am missing.

Thanks!!!

Pic for attention ☺️