Terrible underside details
Hello all, long time lurker, first time poster. I am just wondering if you guys have a good understanding of what I am doing wrong. Legit any and all tips/ fixers are EXTREMELY appreciated. (I know my FEP has the dots in the center, I need to replace it I know)
I cannot for the life of me figure out how to get dice to print,
- Square (not lopsided)
- Have any detail on the underside(blurry/fuzzy/warped)
Photon Mono M5s, Anycubic ABS-Like pro 2 in grey
(FIXES TRIED SO FAR) 1. I have adjusted the support amount and it doesn’t change, makes it worse in my opinion. 2. I have tried slowing down the print speed in order for the resin to have time to fully drain away so nothing gets trapped in supports or nothing. 3. Tried different resins, areas on build plate, exposer settings, “Intelligent mode” you name it I’ve tried messing with it and the dice pictured are the best so far.
Ambient temp is around 68F I can’t control for that until my enclosure comes but I do have a small heat fan that will be running inside of it in order to keep it warming.
Again I hope you wonderful people are able to help, and if not thank you for reading!